Cross Two Clock Domains

Send Signal from a Faster to a Slower Clock Domain

circuit4u
3 min readJun 25, 2023

1. Slower to Faster Clock Domain

It’s pretty straightforward to send signal from a slower clock domain to a faster clock domain. The basic assumption is that the faster clock can always capture the signal changes, i.e. the edge from low to high or high to low in the slower clock domain, provided that the metastability is taken care of. By shifting that signal into a three-bit shift register, the faster clock can capture that rising/falling edge signal to produce a single clock cycle flag signal.

    reg [2:0] edge_detect;

always @(posedge fast_clk) begin
edge_detect <= {edge_detect[1:0], slow_signal};
end

wire fast_clk_flag = edge_detect[1] ^ edge_detect[2];

The XOR operator would capture both the rising and falling edges of the slow_signal. On the other hand, if you only need to capture the rising edge:

wire fast_clk_flag = edge_detect[2:1] == 2'b01;

Now comes the question: how do we pass a one clock cycle flag signal from a faster clock domain into the slower clock domain.

2. Faster to Slower Clock Domain

--

--

circuit4u
circuit4u

Written by circuit4u

memento of electronics and fun exploration for my future self